Advanced lluminated Pulsar 710 Manual del operador descargar pdf (Pagina 22)

a d v a n c e d i l l u m i n a t i o n . c o m

P u l s a r 7 1 0 M a n u a l

these two controls.

4.5.1.1 Mode Control: The mode control consists of a 4 position dip

switch.Itsrangeis0(0000)to15(1111).SeeTable2forthedenition

of the modes. The down position is logic “0”, and the up position is logic

“1”.

4.5.1.2 Variable Controls: The three rotary switches each have 10

positions (0-9). They are identied as“ones,”“tens,” and“hundreds.”

Thus, the total selectable range is 0 to 999. The variable controlled (pulse

width, current, or % current) will depend on the mode chosen.

The Pulsar 710 can be set to operate in one of 15 different modes that do

notrequireahostcomputertobeconnected.Somelevelsoffunctionality

are limited during local control. Table 2 (See pages 23 & 24) shows the

various modes that can be accessed by manipulating the mode control 4

section dip switch on the front panel.

There are four main modes of operation that can be accessed while under

localcontrol.Eachofthefourmainmodescanbecongureddifferently

to make up the 15 total operating modes.

1. Pulsed Mode: While in this mode the operator can select internal or

external triggering. The rotary switches will control the pulse width,

in microseconds, and can be varied from 1 to 999.

2. Constant Mode: The operator can select between absolute and gated

absolute modes. The rotary switches will control the current up to a

maximum of 2A per channel.

a. 1’s switch = 10mA

b. 10’s switch = 100mA

c. 100’s switch = 1A

100's 10's 1's MODE

PULSAR 710 FRONT PANEL CONTROLS

9 6

3 4

Figure 10: Front panel controls

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Sin comentarios

Advanced lluminated Pulsar 710 Manual del operador Pagina 22