Advanced lluminated Pulsar 710 Manual del operador descargar pdf (Pagina 19)

a d v a n c e d i l l u m i n a t i o n . c o m

P u l s a r 7 1 0 M a n u a l

4.4.2.2 Launch Pulsar 710 Controller Utility: To run the program;

go to Start -> Programs -> Advanced Illumination -> Pulsar Controller.

Upon execution of the Pulsar Controller Utility program, the dialog box

showningure9willappear.

4.4.2.3 Pulsar 710 Utility Dialog Box Status Indicators:

4.4.2.3.1 Main Power: A green light and “ON” indicate the main power

switch on the Pulsar 710 is turned on. Otherwise there will be a red light

and “Off”. Settings can be transferred from the host computer to the

Pulsar 710 with the main power switch off. The main power switch must

be “ON” in order to drive the light head.

4.4.2.3.2 Light head: A green light and “Ok” indicate that there is a

light head connected to the Pulsar 710. The type of light head will also be

displayed when available.

4.4.2.3.3 USB Connection: A green light and “Ok” indicate that a

USB connection has been established between the host computer and the

Pulsar710.AUSBconnectionisrequiredtosetupthePulsar710.

4.4.2.3.4 Status Panels: The two panels below the indicators show

connection status details. The top panel shows the results of the last

Figure 9: Pulsar 710 controller utility dialog box

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Sin comentarios

Advanced lluminated Pulsar 710 Manual del operador Pagina 19