Advanced lluminated Pulsar 710 Manual del operador descargar pdf (Pagina 10)

a d v a n c e d i l l u m i n a t i o n . c o m

P u l s a r 7 1 0 M a n u a l

3.2.3 Red: The red light blinks an error

code in the case of an error condition.

The condition is indicated by three sets

of sequential ashes. For example:  4

ashesfollowedby2ashesfollowedby

3ashesindicatesanerrorcodeof423

whichsigniesthatthemainpowerswitch

is off. Two common error codes are:

• 351: No light head detected.

• 423: The main power switch is off.

(Refer to section 6.0 “Troubleshooting” for more detailed error code

information.)

3.3 Local Control

For the purposes of this procedure, the Pulsar 710 will be operated in self

testmodeutilizinglocalcontrol.

Using Figure 1, locate the four section dip switch that sets the operating

mode of the Pulsar 710. Set the four switches to 1110, from left to

right. Logic “1” is set when the switch is up and logic “0” when the

switch is down. This is Mode 14 and enables an internal trigger having a

repetitionrateof10Hz.Thepulsewidthissetbythethree10position

rotary switches at the far left of the front panel. The rotary switches set

the pulse width in microseconds, up to 999 microseconds. A reasonable

starting pulse width for testing is 20 microseconds. Example: Set the

“10’s” switch to “2”, leaving the “100’s” and “1’s” switches set to “0”.

Set the power switch to “on”. The selected mode is activated by the

Pulsar 710 when the power is applied or when the light head is changed.

Assuming that the connected light headiscongured with one ofAi’s

two Signatech options, the Pulsar 710 will set a safe current level for

the light head based on the repetition rate and the pulse width. Older

light head’s without Signatech will cause the Pulsar 710 to shut down

and ash error code 352 (See chapter 6.0 “troubleshooting” for a

complete listing of trouble codes). The pulse width may now be varied

using the three rotary switches. Successful operation in this mode

indicates that the Pulsar 710 and light head are functioning correctly.

PULSAR 710 STATUS INDICATOR LIGHTS

POWER

ERROR

STATUS

POWER

Figure 4: Status indicator Lights

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Sin comentarios

Advanced lluminated Pulsar 710 Manual del operador Pagina 10